Guitar Care

Hand Carved Archtops are Solid wood guitars are made carved solid wood that are directly affected by humidity and temperature.

Humidity is the amount of water vapor or moisture in the air. Temperature affects the amount of moisture that air can hold. Both of these factors affect wood because it is naturally “hygroscopic”. This means that it takes on and gives off water. A guitar that absorbs too much moisture, through high humidity, expands and swells. This distorts the geometry of the guitar and, consequently, its tone and playability. Add high temperature, and humidity can weaken glue joints and even cause them to fail. With prolonged exposure, the glue under the bridge will weaken, allowing the bridge to pull off.

Telltale signs of a wet guitar:

  • High action
  • Swollen top
  • Fret buzzing in the high registers (as fretboard rises with the top)
  • Distorted back and sides
  • Finish cracks Bindings separated

Overly dry conditions, or lack of sufficient humidity, can be equally detrimental to your guitar, causing the wood to shrink and crack. It can also cause poor tone and improper intonation. In dry regions (mountainous or desert areas) or northern climates, where heated air is common in winter, simple guitar humidifiers may not be sufficient. Room or household humidifiers may be necessary to maintain a proper environment. If you run the meaty part of your finger across the grain and you can feel the grain.

This is a major signs of a “dry” guitar:

  • Lowered action
  • Fret buzzing and lifting
  • Fret ends sticking out from the fingerboard
  • Dips in the top or back
  • Finish and/or wood cracks

Gradual changes in humidity and temperature will generally not harm a well-made guitar. Guitars n Jazz maintains 49% relative humidity and a temperature of 75 degrees. So if you keep guitar pretty close to these ranges, you should have no problems.

The biggest danger caused by humidity and temperature is rapid or extreme changes. That’s because different parts of the guitar shrink and expand at different rates. For example, if your local humidity drops very rapidly, the guitar cannot acclimate itself uniformly, causing cracks or failure of glue joints in different portions of the guitar as it tries to “cope” with the drying situation. The same is true, in reverse, with high humidity. Extreme temperatures can wreak havoc, too. Heat weakens glue. Cold “chills” lacquer causing finishes to crack or craze.

While you can’t control the weather, you can control your guitar’s environment to a great extent. Here are some simple pointers.

  • Keep your guitar in its case when you’re not playing it because it’s a lot easier to control humidity in a smaller volume of air.
  • Purchase a home hygrometer/thermometer to keep tabs on the relative humidity and temperature. Adjust your home environment as necessary. Plants and humidifiers add moisture in dry winter months. Air conditioning controls humidity in the hot, muggy summer months.
  • Avoid storing your guitar near sources of hot, dry air (such as forced hot air heating ducts), or cold, damp areas (garages, basements, closets with outside walls).
  • Never, ever, transport your guitar in a car trunk. Temperatures inside car trunks are extreme in any kind of weather. It’s the quickest way to destroy a guitar. Even in the passenger compartment your guitar can be subjected to extreme temperatures. For example, please allow your instrument to warm up slowly before opening your case in a warm room after being transported in a cold vehicle. That’s a sure way to get finish crazing.
  • When traveling cross country, keep in mind changes in local humidity – and protect your guitar accordingly.
  • Guitar humidifiers that fit inside the sound hole or extend into the body can be very effective but must be used with great care to avoid water damage. Check with a qualified guitar repair person before using them.

Fine Guitars are finished with multiple coats of high-grade lacquer, hand-sanded between applications to bring out a deep shine. The resultant finish is thin, durable and acoustically compatible. The best way to preserve this finish is to keep it clean – wiping off perspiration and fingerprints with a soft, damp (not wet) cloth. Old, soft cotton baby diapers make excellent guitar cleaning cloths. While there are many commercial guitar cleaners available, we feel that a rag slightly dampened with plain tap water and thoroughly wrung out will remove most dirt. Then buff with dry clean cloth. If you must use commercial products, avoid those with solvents, silicones or abrasives- Meguire’s Mirror Glaze #7 is a non abrasive wax that is used on the delicate clear coats of cars and works very well on guitars. Less is always best.

Click here for a great link to show many of the problems and solutions